RigPix logo

Icom logo


Back to main

Back to Icom

Next HF and more


Copyright logo


Last modified 2020-04-03

Valid HTML 4.01 Transitional

Icom IC-7100

A picture of Icom IC-7100

SPECIFICATIONS

GENERAL
Type:Amateur HF/VHF/UHF transceiver
Frequency range: TX: 10-160 m + WARC / 6 m / 2 m / 70 cm (and 4 m/70 MHz in Europe)
RX: 0.03-200 / 400-470 MHz
Tuning steps:Down to 1 Hz
Frequency stability:0.5 ppm @ 0-50C (32-122F), after 5 minutes warmup
Mode:TX: AM / FM / SSB / CW / RTTY / DV (D-Star)
RX: AM / FM / WFM / SSB / CW / RTTY / DV (D-Star)
Channels/memory management: 495 regular in 5 banks
3 scan edge pairs
4 call
Non-volatile EEPROM storage
Repeater shift/offset:0-9.999 MHz in 1 KHz steps
Power supply:13.8 VDC 15%
Current drain/power consumption:RX: 0.9 to 1.2 A
TX: Max 22 A
Antenna impedance/connector:50 ohm / Two SO-239
Dimensions (W*H*D):RF unit: 167*58*225 mm (6.58*2.28*8.86")
Controller: 165*64*78 mm (6.5*2.52*3.07")
Weight:RF unit: 2.3 Kg (5.07 lb)
Controller: 500 g (1.1 lb)
Other features: CTCSS/PL and DTCS. Tone scan. 1750 Hz tone burst. CI-V.
D-Star built-in. Dot-matrix touch-screen controller. IF-DSP. Voice recorder.
SD memory card slot. USB audio in/out. Remote control. SWR meter. Keyer.




RECEIVER SECTION
Receiver system: Double conversion superheterodyne (WFM)
1st IF: 134.732 MHz
2nd IF: 10.7 MHz
Triple conversion superheterodyne (AM/FM/SSB/CW/RTTY)
1st IF: 124.487 MHz
2nd IF: 455 KHz
3rd IF: 36 KHz
Sensitivity: AM (10 dB S/N)
0.5-1.8 MHz: 13 uV
1.8-29.9 MHz: 2 uV
50-54/70 MHz: 1 uV
144/430 MHz: 1 uV
FM (12 dB SINAD)
28-29.9 MHz: 0.5 uV
50-54/70 MHz: 0.25 uV
144/430 MHz: 0.18 uV
WFM (12 dB SINAD)
76-108 MHz: 10 uV
SSB/CW/RTTY (10 dB S/N)
1.8-29.9 MHz: 0.15 uV
50-54 MHz: 0.12 uV
70 MHz: 0.15 uV (European version only)
144/430 MHz: 0.11 uV
DV (D-Star, 1% BER)
28-29.7 MHz: 1 uV
50-54/70 MHz: 0.63 uV
144/430 MHz: 0.35 uV
Selectivity: AM (BW=6 KHz, filter set to Sharp)
6 KHz (-6 dB), 10 KHz (-40 dB)
FM (BW=15 KHz, filter set to Sharp)
12 KHz (-6 dB), 22 KHz (-40 dB)
SSB (BW=2.4 KHz, filter set to Sharp)
2.4 KHz (-6 dB), 3.4 KHz (-40 dB)
CW (BW=500 Hz, filter set to Sharp)
500 Hz (-6 dB), 700 Hz (-40 dB)
RTTY (BW=500 Hz, filter set to Sharp)
500 Hz (-6 dB), 800 Hz (-40 dB)
Image rejection: HF/6 m: 70 dB
2 m/70 cm: 65 dB
AF output power/speaker:2 W at 10% distortion / 8 ohm
External speaker connector:3.5 mm, 8 ohm (2-conductor)




TRANSMITTER SECTION
RF output power:
HF2-100 W (AM 1-30 W)
6 m2-100 W (AM 1-30 W)
4 m/70 MHz2-50 W (AM 1-15 W), European version only
2 m2-50 W
70 cm3-35 W
Modulation system: AM: Digital low power modulation
FM: Digital phase modulation
SSB: Digital PSN modulation
DV: GMSK digital phase modulation
FM deviation:FM: 5 KHz
NFM: 2.5 KHz
Spurious emissions:Less than -40 to -60 dB
Microphone impedance/connector:600 ohm / 8-pin (Modular)
Microphone input level:? mV




MISCELLANEOUS
Manufactured:Japan, 2013-2019 (Discontinued)
Additional info:New price 2014 in Sweden: SEK 14950:-
Related documents: Pre-release info (725 KB)
User manual (24.8 MB)
Advanced manual (19.8 MB)
Modifications and fixes:
Reviews:
Options/Accessories:
AH-2b
AH-4
AT-180
CT-17
HM-36
HM-103
HM-151
HM-198
MB-62
MBA-1
MBF-1
OPC-420
OPC-589
OPC-599
OPC-742
OPC-1529R
OPC-2218LU
OPC-2253
OPC-2254
PS-126
RS-BA1
SM-30
SM-50
SP-35
Mobile antenna element. 7-54 MHz
Auto-ATU, HF/6 m
Auto-ATU, HF/6 m
CI-V level converter
Hand microphone with up/down buttons (OPC-589 adapter required)
Hand microphone with up/down buttons
Remote control microphone
Hand microphone with up/down buttons
Mobile mounting bracket
Mounting bracket
Suction cup mounting base
Shielded control cable
Microphone adapter cable
ACC adapter cable. 13-pin to 7-pin + 8-pin ACC
ACC cable. 13-pin
Data communication cable. RS-232C
Data communication cable. USB
Control cable. 3.5 m (11.5 ft)
Control cable. 5 m (16.4 ft)
Power supply. 13.8 VDC, 25 A
IP remote control software
Desk microphone (OPC-589 adapter required)
Desk microphone (OPC-589 adapter required)
External speaker. 4 ohm, 7 W