| GENERAL |
| Type: | Citizen band transceiver |
| Frequency range: | 26.965-27.255 MHz |
| Channels / tuning steps: | 23 |
| Mode: | AM / SSB |
| Frequency control: | XTAL matrix |
| Frequency stability: | ?% |
| Clarifier or Delta tune: | ±? KHz |
| Power supply: | 13.8 VDC (Male octal jack) |
| Current drain / power consumption: | RX: ? mA
TX: ? A |
| Antenna impedance / connector: | 50 ohm / SO-239 |
| Dimensions (W*H*D): | 165*60*223 mm (6.5*2.36*8.78") |
| Weight: | ? g (? lb) |
| Other features: | PA. NB. |
|
|
|
|
| RECEIVER SECTION |
| Receiver system: |
Single conversion superheterodyne (SSB)
IF: ? MHz
Double conversion superheterodyne (AM)
1st IF: ? MHz
2nd IF: 455 KHz
|
| Sensitivity: | |
| Squelch sensitivity: | |
| Selectivity: | |
| Image rejection: | |
| AF output power / speaker: | ? W at ?% distortion / ? ohm |
| External speaker connector: | 1/4" jack or TS "Minijack" (3.5 mm), depending on version |
|
|
|
|
| TRANSMITTER SECTION |
| RF output power: |
AM: ~3.5 W (5 W input)
SSB: ~12 W PEP (25 W PEP input)
|
| Modulation system: | |
| Max AM modulation (Factory set): | ?% |
| Max FM deviation (Factory set): | No FM |
| Spurious emissions: | Better than -? dB |
| Microphone impedance / connector: | ? ohm / 5-pin DIN |
| Microphone input level: | ? mV |
|
|
|
|
| MISCELLANEOUS |
| Manufactured: | Japan, 1976-1977 (Discontinued) |
| Main PCB: |
1001C by Tokai
|
| Sub PCBs: | |
| Additional info: | |
| Related documents: |
AF amplifier: Two 2SB474
RF final: 2SC1307
|
| Known markets and approvals: |
USA
FCC: Vol.6, part 95 compliant
|
| Sams Photofact #: | None |
| Modifications and fixes: | |
| Reviews: | Electronics Australia: June 1977, page 41 |
| Options / Accessories: |
|
